is it possible to use labview as pid controller to control load

However, adding more and more signals to it is a burden. It is capable of handling a sufficient number of analog and digital signals. It acts as a controller for closed-loop system(s) and executes combinational or sequential logic repeatedly through the ladder diagram (LD). The contribution of a programmable logic controller (PLC) in an automation system is significant. This design can be used either with or without a PLC. The time required to execute two closed-loop controls was identified as 18.96000004 ms. ADC combined with dedicated PID controller logic in an FPGA for every closed-loop control system confirms concurrent execution of multiple PID controllers. Digital input to the PID controller is routed by the novel idea of analog to digital conversion (ADC), performed using a digital to analog converter (DAC), comparator, and FPGA. Concurrent execution of multiple PID controllers was assured by assigning separate FPGA hardware resources for every PID controller. In this research work, a field-programmable gate array (FPGA)-based multiple PID controller is proposed to retain PLC scan time at a lower value. The analog input module in the PLC converts these analog signals into digital signals and forwards them to the PID controller as inputs. Process parameters are measured as analog signals. Adding more process parameters slows down PLC scan time. It contains as many PID function blocks as the number of process parameters to be controlled. An LD also has PID controller function blocks. A programmable logic controller (PLC) executes a ladder diagram (LD) using input and output modules.

Is it possible to use labview as pid controller to control load